![]() Simply browse to the same folder where you placed the ABR files. ![]() The correct brushes folder should open, but dont worry if it doesnt. In the menu that pops up, select Import Brushes. In the parameters below, changes are made from minimum value to maximum value for “starting” and vice versa for “ending”. Click the Settings icon in the top right corner of the brush panel. The area becomes longer the faster the speed. ⑤ Starting and ending by speed: When this is set to “ON”, the area of the starting and ending will be changed depending on the speed. Also, this specifies the area with a value. ④ Ending: When this is set to “ON”, the parameters change, depending on the range of the “ending”. ③ Starting : When this is set to “ON”, the parameters change, depending on the range of the “starting”. (You cannot configure the starting (ease in).) Fade : The value up to the minimum value within the specified length is gradually reflected. By percentage : Specify the proportion when considering the length of a line is 100%. Specify length : Specify the area for starting and ending. ② How to specify: Specify an area for starting and ending (easing in and out). ① Starting and ending: These settings reflect the specified parameters of the “starting “ and “ending” of a line, regardless of the pen pressure.Ĭonfigure the which is displayed when clicking on the button right to the “What and how to change”. ![]() The larger the value, the stronger the snapping becomes. ⑩ Vector magnet: When drawing near a line that is already drawn on a vector layer, this setting configures how it will attract another line. ⑨ Able to snap : Configure snap setting for the ruler. The larger the value, the longer it will ease out. ⑧ Brush stroke : When a stroke is ending with diminishing pen pressure, this adjusts how much easing out will follow. When used on a vector layer, adjustments will be made using a Quadratic Bezier when adjusting a curve at a later time. ⑦ Bezier curve : If this is set to “ON”, the curve with correction becomes a Quadratic Bezier. This is because when the display scale has a large value, it is most likely that for drawing a detailed segment a strong correction is not needed. The smaller the display scale is, the stronger the correction will be. ⑥ Adjust by display ratio: If this is set to “ON”, you can adjust the strength of the correction by its scale. In case you want to draw detailed parts thoroughly, it is a valid option, to not use the correction. ![]() ⑤ Adjust by speed : If this is set to “ON”, the faster the drawing speed is, the stronger the correction becomes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |