![]() ![]() If you combine the time and labor necesarry to complete this, you’ll be standing, holding, and pushing a chainsaw for several hours for one completed beam. ![]() It could take another couple of hours to plane down every side. Once you finish cutting the beam to size, you also have to plane down the sides to smooth out the kerf marks left by the chain. This is without taking any breaks and only one cut on each side. To cut a standard 8×8 beam that’s 12 feet long would take at least three hours from start to finish. Milling your own lumber with a chainsaw takes a long time. Plus, you’re supporting a local business. If you use chainsaws already you probably have most of these things.īy the time you buy all the equipment you need, it probably would have been cheaper to buy boards from a local sawmill. This includes but is not limited to: chaps, ear protection, eye protection, and gloves. Last but not least, make sure you have all the necessary safety equipment. You can use a regular cutting chain but you won’t have as nice of a cut. These can range from $20-$50 for a single chain. Third, for the best results, you need a ripping chain. If you don’t already have a chainsaw that you can use, this can be an expensive investment. ![]() You need the longer bar to be able to cut all the way through a log. Second, you need a chainsaw that can handle a longer bar. Let’s go down the list.įirst, you need a mill, these can range anywhere from $25-$2,000 depending on size and quality. However, that doesn’t count the other gear that you need to effectively mill lumber. You can buy chainsaw mills that are relatively inexpensive. Just thinking about all the work that goes into a single log makes me tired. In between cuts, you also have to manually flip the log in order to cut every side. And that’s just for a single log.īefore you even begin the cuts, you also have to set up our guide beams or frame so you can cut a straight line. This can wear you down very quickly and isn’t very good for your back.ĭepending on what you’re trying to cut, beams or boards, you will have to make at least four cuts for a beam and more cuts for boards. In order to get the smoothest cut, you have to slowly pull the chainsaw through the timber. That’s pretty much what this whole section is about. LaborĬhainsaw mills are exhausting to use. We’ll go into each reason one by one to better explain what we mean. Like we stated in the intro, chainsaw mills aren’t worth it for four reasons: labor, cost, time, and waste. We’ve got a lot to cover, so let’s get going. In this post, we’ll dig into the reasons why chainsaw mills aren’t worth it. The physcial labor, the cost of the mill and equipment, the time needed to produce the lumber, and the waste produced by the chainsaw. In short, chainsaw mills are not worth it for four reasons. So, the question is, are chainsaw mills worth it? But they can be rather expensive and labor intensive. Chainsaw mills can produce some lovely straight boards and beams. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |